HOME / Q & A / About Mechanism / 1- Machanical & processing Questions

● NC-350A1 About delay time setting (for stop ram at top)

Ans:

Under normal condition, the ram will stop at the top, feed sensor will light up after the slotting job finished, and the workpiece will move out to the workpiece replacement position!
If the ram does not stop at the top (the feed sensor will not light up), the workpiece will not move out to the workpiece replacement position after processing, so as to avoid crash accident!
See the attached picture with normal situation description.

 

 

solution:
Please adjust the delay time according to the attached instructions so that the ram stops on top position and confirm that the feed sensor is light up.   Using manual mode to test, first try to see if the ram stops at the top by adding 0.1 each time.