HOME / Q & A / About Controller / 2-Controller problems

● CNC-450 How to move up protective cover during program run period

Ans: 

After press cycle start but you would like to temporarily stop program running to check some things , We had designed a parameter to allow user to move up protective cover during program run period, The parameter No. is 3446  , Please press F6 Parameter key then press F5 Goto Parameter then input 3446  then

Input password “ 520 “ to enter 3446 parameter setting screen , You just set 3446 value at 1  (ON)  then controller will Allow you to move the protective cover during program running period .

(refer to attached photo)

 

As for how to move the protective cover : Please find Ram up key at left keyboard , It’s right side of Oil stop key , Please press Ram up to move protective cover up , Besides please note that Ram Run key is for moving Ram protective cover down