HOME / Q & A / About Controller / 2-Controller problems

● Instruction how to set XYZ axis home position

Ans: 

It mean the machine need to set the  X,Y,C machine home position ,

Hereby we teach you how set the X,Y,C home position as following procedure :

  • Step1 : Turn on power
  • Step2: Switch to MPG mode then move the X,Y,C axis at black arrow mark position  (refer to attached picture)**
  • Step3: Switch to Home mode
  • Step4 Press F6 param setting key
  • Step5:Press F7 Serial Tuning key
  • Step6: Input password 520 then press Enter
  • Step7: Press F1 OK
  • Step8: Press F7 Abs Home setting key
  • Step9:You can see X,Y,C axis Home setting screen , You will see X,,Y,C axis shown “Unset”
  • Step10: Check and confirm X axis  , Y axis , C axis is at correct black arrow mark position.
  • Step11: Move cursor to X and press F1 Home OK to set X axis machine Home position , then you will see X unset change to set  OK
  • Step12  Move cursor to Y and press F1 Home OK to set Y axis machine Home position , then you will see Y unset change to set  OK
  • Step13: Move cursor to C and press F1 Home OK to set C axis machine Home position , then you will see C unset change to set  OK
  • Step14: Finish X,Y,C axis Home setting procedure  , then you can execute Home normally.